Titan Pinball Kits DatabaseSwords of Fury
Rubber
Ring Kit by Anonymous
(0)
Williams Electronics Games, Incorporated, a subsidiary of WMS Ind., Incorporated , June, 1988
4 Players
Description
Kit Contents Print
Post Sleeves - Tapered Post
Yellow
Qty: 3
Post Sleeves - Standard
Yellow
Qty: 6
Rubber Rings - 5/16 Inch I.D.
White
Qty: 10
Rubber Rings - 3/4 Inch I.D.
White
Qty: 1
Rubber Rings - 1 Inch I.D.
White
Qty: 2
Rubber Rings - 1 1/2 Inch I.D.
White
Qty: 2
Rubber Rings - 2 Inch I.D.
White
Qty: 2
Rubber Rings - 2 1/2 Inch I.D.
White
Qty: 2
Rubber Rings - Shooter Tip
White
Qty: 1
Rubber Rings - Flipper Mini
Red
Qty: 1
Rubber Rings - 7/16 Inch O.D.
Red
Qty: 1
Rubber Rings - 3/8 Inch O.D.
White
Qty: 7
Rubber Rings - Flipper Standard
Red
Qty: 3
Comments
2020-05-16 21:24:09 Dave W. wrote:
I switched out a couple of the rings from 1" to 3/4". There are a few posts that have the same spacing, (around 2" OC) yet the manual specifies different rings for them. It will make sense during install. I will update and add photos once I play the game for a bit.
2020-05-22 00:46:36 Dave W. wrote:
See my photos and description. Notice that I was to lazy to remove the upper PF and install all the yellow post sleeves in the photos. I will when I rebuild upper PF flip. New ramps by Freeplay40 (Pinside)
2020-05-22 00:56:20 Dave W. wrote:
The other small rubber on upper PF could be either 1" or 3/4"...I like the xtra bouncy action of the larger 1" rubber.
2020-05-22 01:06:05 Dave W. wrote:
Note: Cliffy's installed and lower PF flips are great with standard rubbers, no ball hop.