Titan Pinball Kits DatabaseGodzilla (Premium/LE)
Rubber
Ring Kit by Eric B.
(2)
Description
Kit Contents Print
Rubber Rings - 3/8 Inch I.D.
Red
Qty: 1
Rubber Rings - 1 1/2 Inch I.D.
Translucent
Qty: 1
Rubber Rings - 2 1/2 Inch I.D.
Translucent
Qty: 2
Rubber Rings - 7/16 Inch O.D.
Translucent
Qty: 2
Rubber Rings - Shooter Tip
Red
Qty: 1
Rubber Rings - Low Bounce Standard Flipper
Green
Qty: 3
Post Sleeves - Stern Slim Tapered
Grey
Qty: 1
Rubber Rings - 7/16 Inch O.D.
Red
Qty: 1
Rubber Rings - 3/8 Inch O.D.
Translucent
Qty: 2
Post Sleeves - Stern Slim Tapered
Glow
Qty: 3
Post Sleeves - Stern Slim Tapered
Red
Qty: 1
Rubber Rings - 7/16 Inch O.D.
Grey
Qty: 1
Rubber Rings - 7/16 Inch O.D.
Orange
Qty: 3
Comments
2022-11-07 22:01:43 Mark S. wrote:
Eric, I ordered this kit, thanks for putting it together. The kit looks great on the machine, the lower playfield and Maser areas really open up with the translucent slings. The one thing I'm kinda scratching my head about are the two 3/8" OD Translucent rings? There's only two of those wee teeny guys but I can't seem to figure out where you used them?
2022-11-20 18:20:07 Eric B. wrote:
Hey Mark, the two 3/8” OD are for the bumpers on either side of the outlanes to the right & left of the slings.
Hope that clears it up!
Hope that clears it up!
2023-01-01 15:34:26 Scot J. wrote:
I’m still not clear where those 3/8” translucent go. Any chance you can add a pic showing where they go? Otherwise, awesome kit - really love how it improves my table!
2023-03-16 07:32:28 Eric B. wrote:
Hey Scot, The last pic shows one of them right above the left outlane "Mothra Ball Save". The other is on the other side above the "Oxygen Destroyer" outlane.
2023-03-16 15:05:20 Jesse P. wrote:
Just installed the kit and couldn’t find where the 3/8” translucents go either. According to manual the ones you are referring to are 7/16” as were the black I removed. As far as I can tell there are no 3/8” unless I’m missing something….
2023-03-25 10:29:36 Eric B. wrote:
Jessee, Stern does 7/16" rubber bumpers but with these Titan silicone ones, I have found to be, too bouncy and cause the ball to bounce back into the outlane & drain a lot more than rubber. I substitute 3/8" for the outlines because they aren't AS bouncy and they cut down on the bounce outs. Hope that helps!